What happens when your tires are already on rims
A wheel swap is the shorter job. A typical sequence looks like this, though each approved independent partner shop confirms its own process:
- The vehicle is lifted and the current wheels come off.
- The incoming set is checked for cuts, cracks, blisters, bulges and remaining tread. Transport Canada says tires with deep cuts, cracks, blisters or bulges should be replaced.
- Directional tires are checked so they go on the correct side of the vehicle, as Transport Canada advises.
- Wheels go on and the wheel nuts are tightened to the vehicle manufacturer's specification, which is listed in your owner's manual.
- Pressures are set to the cold pressure on the tire information label on the driver's door edge or door post, not the maximum printed on the sidewall.
What happens when tires need mounting and balancing
With only one set of rims, every changeover includes the full tire service:
- Each wheel comes off and the outgoing tire is removed from the rim on a tire machine.
- The incoming tire is mounted on the same rim, with care around the valve stem and any tire pressure monitoring (TPMS) sensor inside the wheel.
- The tire is inflated and seated, then the assembly is spun on a balancer and weights are added to correct any imbalance.
- Wheels go back on, nuts are tightened to specification and pressures are set.
Why balancing matters on a remount
Balancing is not an upsell on this job. NHTSA states that new tires should always be balanced when installed. A tire that has been dismounted and refitted also sits on the rim as a new combination, so it gets balanced as part of the mount.
Transport Canada explains the stakes: a wheel that is out of balance can cause a pounding or shaking through the steering wheel or seat. That pounding can shorten the life of suspension components, cause uneven tire wear and increase fuel consumption. If you feel a new vibration after any changeover, report it to the partner shop.
Make next season a wheel swap
Build a winter tire-and-wheel package with free Canada-wide shipping, or request a changeover for the tires you already have through an approved independent partner shop.
Why a second set of wheels saves time every season
Buying winter tires on their own wheels is an up-front decision that pays back twice a year, every year.
- Fewer steps. A wheel swap skips dismounting, mounting and balancing, so the changeover itself is shorter.
- Less handling of the tire. Every dismount and mount works the tire bead over the rim edge. A wheel swap removes that step each season.
- Your main wheels stay out of the slush. Many drivers keep a separate winter set so road salt and snowbank curbs hit the winter wheels, not the summer ones.
- Simpler planning. A wheel swap is a predictable job, which makes it easier to fit in when the partner shop confirms timing.
Side by side, with real driver setups
Here is how the choice plays out for four common setups:
A Brampton driver with two sets of wheels requests a changeover on rims. The Brampton partner shop has an alignment rack, so if the driver has noticed uneven wear on the inside or outside edges, an alignment check can be added to the request. Transport Canada suggests an alignment check once a year or whenever you see that kind of wear.
A Pickering driver with one set of factory alloys has a mount and balance every spring and fall. Pairing the winter tires with a second set of wheels would make future changeovers a wheel swap. The Pickering partner shop has no alignment rack, so an alignment would need a partner shop in Brampton, Mississauga, Burlington or Kingston.
A North York driver is buying new winter tires only. The first install is a mount and balance on the existing rims. If the plan is to keep the factory wheels for summer, adding a set of wheels now saves that step every season after. The North York partner shop has no alignment rack.
A Kingston driver orders a winter tire-and-wheel package through the package builder and chooses installation at checkout. Tax and eco fees are shown before paying, and from next season on, every changeover is a wheel swap.
Checking TPMS and requesting your changeover
One detail to settle before you buy a second set of wheels: tire pressure monitoring. NHTSA explains that direct TPMS uses sensors located in the tires, while indirect systems rely on wheel speed and other vehicle sensors. If your vehicle uses direct sensors and the winter wheels do not have them, the warning light may not behave as expected. Check your owner's manual, and mention TPMS when you request a quote.
When you send the quote form, include the details that decide the job: vehicle year, make and model, tire size, whether the tires are on rims, whether there are TPMS sensors, whether you want an alignment, and your preferred partner shop city. The reply comes by email, and the approved independent partner shop confirms timing.
Key takeaways
- A changeover on rims is a wheel swap; tires off rims need dismounting, mounting and balancing every season.
- Pressures should always be set to the door label, not the sidewall maximum, after any changeover.
- A second set of wheels removes mounting and balancing from every future changeover.
- Partner shops in Brampton, Mississauga, Burlington and Kingston have an alignment rack; North York and Pickering do not.
- Tell the partner shop your rim setup, tire size and TPMS details in the quote request.
Frequently asked questions
Do I need an alignment with every changeover?
Not automatically. Transport Canada suggests an alignment check once a year or if you notice uneven or rapid wear on the inside or outside edges of a tire. If you want one, choose a partner shop with an alignment rack: Brampton, Mississauga, Burlington or Kingston.
If my tires are on rims, do they need balancing every season?
Not usually as part of a wheel swap. If you feel pounding or shaking through the steering wheel or seat, which Transport Canada links to an out-of-balance wheel, mention it in your request so the partner shop can check it.
Steel or alloy wheels for winter?
Either can work as long as the wheel fits your vehicle. The choice usually comes down to appearance, budget and how you feel about road salt on your wheels. Browse wheels in the marketplace or let the package builder pair tires and wheels for you.
How long does a changeover take?
Timing is confirmed by the approved independent partner shop. A wheel swap has fewer steps than a mount and balance, which is one reason a second set of wheels is popular with drivers who change over every year.
Can someone come to my driveway to do it?
No mobile service is offered. Changeovers are done at approved independent partner shops in North York, Brampton, Mississauga, Pickering, Burlington and Kingston.
What if a package does not suit my vehicle after it arrives?
Unopened, unused products can be returned within 90 days with no restocking fee. Check the return policy for the details before you install anything.
Sources
Technical review
Faisal Mohammad, Licensed Automotive Service Technician
Faisal Mohammad is a Licensed Automotive Service Technician and operations partner at Winter Tire Change Near Me. He has 22 years of experience in the automotive industry, with extensive experience in tires, wheels, automotive repairs and partner-installer operations across Ontario.